This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (2 messages)
Howdy, The problem is that the number of blocks per cylinder default is set wrong. Try giving RDPrep a figure one less than the default it gives you for useable blocks/cylinder. I think someone at Microbotics was starting at one instead of zero. Hope this helps. WVK -71410,724
#27426-
Hardframe 2000
Message #27471
The board is very clean. The only jumper are for autoboot and multi card setup. I think there are two jumpers for board id and one to turn autoboot on or off. There is another slot on the jumper block to plug your harddisk LED into. The software is made…