CompuServe Archive

This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.

Forum: User CIS ID:

From Date: To Date:

Search Results (4 messages)

#173866– #INSTALL 3DS R4 Message #174036

From: Jack Autodesk Multimedia Forum · Autodesk 3D Studio June 6, 1995 8:51 PM

WEll, i think too…i change motherboard, i think is a ordinary chip-set, non-named, Thanks for attention. JAck

#173774– #INSTALL 3DS R4 Message #173855

From: Jack Autodesk Multimedia Forum · Autodesk 3D Studio June 5, 1995 11:03 PM

DOS 6.22 I have it: Green Pc Motherboard (i think, is a cause of fault) Intel Overdrive DX2 66mhz 20 mb ram 72 pin 70 ns 4Mx36 in one bar EIDE VLB Winbond/Primise 2300 High speed i/o 16552C Diamond Speedstar pro ISA

#173645– #INSTALL 3DS R4 Message #173703

From: Jack Autodesk Multimedia Forum · Autodesk 3D Studio June 5, 1995 9:55 AM

I try using QEMM,Himem,EMM386, and clean boot(F5)…all dont works… Need help, Thanks. Well, i just press F5, clean boot. But dont works, i have use it… But is a correct msg: Abnormal Program Termination: Memory Protection Fault CS:EIP = 000Fh:0022C948h i have 16 mb ram (4Mx36 70 pin 70 ns)

#INSTALL 3DS R4 Message #173621

From: Jack Autodesk Multimedia Forum · Autodesk 3D Studio June 4, 1995 9:53 PM

I have problems with install 3DS r4, when i finish, run 3ds vibcfg, for configure Vibrant Drivers, but i recived this message: Some function(s) not defined, invalid VLM combination. Vibrat configuration failure 1. when i run without config Vibrant: ERROR: 3ds.set error in line 24: VIB-FLIC= 63 640 480 256…