#Bernoulli Box w/Amiga?
4 messages in this thread
Has anyone used a Bernoulli Box with their Amiga?
I hooked one up to my A3000 and HDToolBox can find the drive but does not
recognize LUN 1 of SCSI address 0. Any way to do this?
I can low level format the drive and save the changes to the drive but after
the reboot the drive is not recognized and does not appear on the workbench.
HDToolbox reports only 4 MB when I try to partition the disk.
Does anyone have a list of parameters for a drive type that will make this
drive work an Amiga?
-J
Jay,
I have a Bernoulli Transportable 150 on my 3000. My advice to you is junk
HDToolbox – it's totally useless. Download RDPrep from AmigaVendor – the
filename is RDP391.LHA in Library 16. It's about 100K. Decompress it,
run it and follow it's instructions. It's not too hard to work with that
program but if you run into any difficulties, message me.
Rick – On Autopilot from Sunny Vancouver
Thanks for the tip, I'll check it out ASAP next week.
-J
Jay,
After you have downloaded RDPrep, remember to read the compatibility notes
file. You have to add the line
DEVICE=scsi.device
to the Tool Types section of the RDPrep icon to work with your 3000's SCSI
port.
Rick – On Autopilot from Vancouver