All trees in the Nursery IPAS for Schreiber keep scaling at inches insted of
feet.
Even when I change the Nursery.SCL increment, tree keep coming out at inches.
Makes a very nice vertice intesive weed.
Since most of my work is architectural, "Drawing Aids" is set up for 1 unit = 1
inch.
Any ideas would help.
Thanks !
David:
Someone may have already replied by now (I am behind on reading the messages),
but in case they haven't:
Try setting you architectural units to 1 unit = 1 foot temporarily just to
generate the tree, and then set it back to 1 unit = 1 inch. The tree should be
created at the proper size, i.e. if the specified height is 20', the tree will
measure 20' in height. Hope this helps.
Bob Keefer, AIA