#HD HELP
3 messages in this thread
I have the second hard drive (a Seagate ST3600A) in my 4000/040 working
(played around with the jumpers on the factory 120 meg drive and made the
ST 3600A the master (I think)), but I have to warn-reboot after a cold
boot for the new drive to show up on the workbench or on INFO.
I tried a WAIT 60 in my startup-sequence incase it was a spin-up problem
but the didn,t help.
Any suggestions?
Jim R. Ollick
Using AP from Bergenfield, NJ
Hi there Jim,
Have you tried increasing the wait command to see what
happens??? Try mounting the extra drive from the CLI to see if it
responds. Could the problem be with the controller or are you using the
A4000 onboard systems… Hope I jogged your braincells a bit :8^)=
STARFIRE cruising the stratosphere
MOTOROLA 040 and AUTOPILOT ENGAGED!
Paul,
Thanks for your reply.
I tried a WAIT 60 (which seemed to make it wait forever). I'll try the
mount command from the CLI to see if it works. I am using the onboard IDE
controller in my 4000/040.
Jim R. Ollick
Using AP from Bergenfield, NJ