#ant make MATROX work !
5 messages in this thread
I sent my Martox illuminator back to the factory for repair, Upon
receiving it back 3ds would not reconize it . The message was
unreconizable verson of PRODRIVE.SYS. I'm in the middle of
production and would appreciate any advice you can give me! The
Matrox people could not offer any advice. The ONLY chang to my system
was installing the 3ds verson 4C1, the update.
The board is abe to load targa files out side 3ds ok.
Thanks ,
-Richrad Sher+
Rich,
>> I sent my Martox illuminator back to the factory for repair, Upon receiving
it back 3ds would not reconize it<<
You must make sure that you run the PROCFG.BAT program (or what ever
its called lately) on any new 3DS executable. It add CALLBUFFS 1 to
your 3DS pharlap settings. You should be able to find the BAT file
in your 3DS directory. Also, the latest version of the driver set is
1.41. Look at your boot-up sequence and verify that the PRODRV.SYS
is loading in your config.sys and that you are using the latest
version of the software.
As an additional note, if you are using the CCIR board (720×486), then
the default resolution of the RDPADI driver doesn't set the pixel
aspect ratio correctly (it uses a value of 1). Define one of your
"resolution buttons" in the 3DS.SET file to 720,486,0.9.
Hope that helps
Ang, President Dynamic Technologies, Inc. An Autodesk Systems Center for
Multimedia in MD
Thanks for the advice…
I'll try your suggestions right away.
-Richard Sher+
<<The message was unreconizable version of PRODRIVE.SYS. >>
In addition to Angelo's comments, if they upgraded your chip set or
BIOS version you may need an update to the Illuminator Drivers. Check
out their BBS at 514-685-6008.
Thanks Brian.. I go it working . All that I needed to Do was run cfgpro.bat
that configured Pharlap…
Back To Work for now .