CompuServe Thread

#Out of space blew C: !

5 messages in this thread
#101328From: Mike RatledgeMay 12, 1994 1:54 PM
Well, here's a good one for ya! I had a rendering FLIC blow up on me with an "out of space on temporary drive" message with only a "Continue" button to choose. When I did, everything on my C: drive (which is a 1.3GB drive) was blown away. I don't have any other drive, and there's over 1/2GB free on there! Any ideas?
#101332From: Jonas Ruikis [ADESK]May 12, 1994 2:08 PM
Mike, << Well, here's a good one for ya! I had a rendering FLIC blow up on me with an "out of space on temporary drive" message with only a "Continue" button to choose. When I did, everything on my C: drive (which is a 1.3GB drive) was blown away. I don't have any other drive, and there's over 1/2GB free on there! Any ideas? >> What? …. How many frames was the flic? After rendering a few frames what are the results of Info-Status (ie. "?")? jonas[adesk]
#101335From: Yost GroupMay 12, 1994 2:24 PM
It sounds like you were probably rendering in High Palette mode and your hard disk controller SEVERELY choked at some point… not necessarily because you ran out of disk space. A flaky disk controller can do almost anything. – G
#101784From: Mike RatledgeMay 14, 1994 10:47 PM
I think you're likely right, Gary. I just had to swap the controller out and then re-low-level and start from scratch (it's a 1.3GB ESDI drive – not your 'average' stuff, these days….).
#101809From: Yost GroupMay 15, 1994 10:21 AM
Good luck, Mike. – G