view file problem
7 messages in this thread
We are experiencing a problem returning to 3DStudio after viewing a 320×200
or 640×480 flic file. The machine just hangs. Any suggestions?
Thanks, Bob Neeb – Spectrum 7
What kind of machine is it? What memory manager are you using? What kind
of display card is in it? What display driver are you using? Do you have
an RCPADI device configured? What does your autoexec.bat and config.sys
look like?
Before we can help you figure out what's wrong with your system
environment, we've got to know more about the environment. Thanks,
– G
You are correct. I did not think through the content of my message. One of
the replies hit the nail on the head. The machine is not locked, The video
state is just not returned properly. Going into the materials ediith the
function keys and back to the editor restores the screen properly. The
other message mentioned old drivers… Where should I look for New drivers.
VGA. Thanks
Operating on the theory that you check the easy-to-fix things first, are
you sure it's locked? When we were using old drivers a while back we had
similar results, but it turned out if we went to the materials editor with
the function key and then back to the editor/keyframer, the display would
correct itself.
–Noah
This wouldn't be a PS/2 95, would it? Or other machine running XGA?