#INSTALL 3DS R4
8 messages in this thread
I have problems with install 3DS r4, when i finish, run 3ds vibcfg, for
configure Vibrant Drivers, but i recived this message: Some function(s) not
defined, invalid VLM combination. Vibrat configuration failure 1. when i run
without config Vibrant: ERROR: 3ds.set error in line 24: VIB-FLIC= 63 640 480
256 2099926 ; VESA … i edit 3ds.set and kill this line(24), i recived this
msg: Abnormal program termination: Page Fault (or memory) CS:EIP = 000fh:00….
I have Intel DX2 66MHz 20 mb Ram. I really need a help… Thanks..
Jack
Are you using Qemm or Memmaker? If so boot while pressing F5 key and the run
3dshell. Then 3 D Studio should load up. The exit out re boot and run 3 D
Studio and it should be fine.
Mike White [SDP]
I try using QEMM,Himem,EMM386, and clean boot(F5)…all dont works… Need
help, Thanks. Well, i just press F5, clean boot. But dont works, i have use
it… But is a correct msg: Abnormal Program Termination: Memory Protection
Fault CS:EIP = 000Fh:0022C948h i have 16 mb ram (4Mx36 70 pin 70 ns)
I'll need more info on your system configuration. It might be a bad memory chip
or a scratch on the mother board. This is all I can tell for your messgg.
Mike
DOS 6.22 I have it: Green Pc Motherboard (i think, is a cause of fault) Intel
Overdrive DX2 66mhz 20 mb ram 72 pin 70 ns 4Mx36 in one bar EIDE VLB
Winbond/Primise 2300 High speed i/o 16552C Diamond Speedstar pro ISA
This a good one. It might be the mother board. It sounds like you have a system
like mine , but I don't seem to be encountering your problems.
I think about it and will get back to you .
Mike
WEll, i think too…i change motherboard, i think is a ordinary chip-set,
non-named, Thanks for attention. JAck
Your welcome . I'll still keep it in mind.
Mike