#DOpus 4.0 – New Bug
4 messages in this thread
Jonathan,
I found another bug in Dir Opus 4.0. Sometimes when I click on the
small Iconify button, Dir Opus just totally disappears. It does not appear
anywhere on the WB screen. However, when I try to run it again, a
requester states that Dir Opus is already running. I also cannot Uniconify
it with the hot key sequence. Apparently, Dir Opus is still running, but
it cannot be seen nor uniconified. I either have to run Dir Opus again, in
which case I'll have two versions running, or reboot.
It only happens intermittently, but it happens enough to be a problem.
😎 I hope this fix will also be in 4.01.
Thanks for listening. Also, I think Dir Opus 4.0 is a marvelous
program. I just finished reading the manual and have configured everything
except the buttons and menus, which I'm still working on. Keep up the
great work.
Dom Fontana
<– Sent from New York via AutoPilot –>
I ran into this too. When I changed my hot key comination everything
was fine again.
Dennis ….on AutoPilot
Dennis,
Do you mean that when you changed the default hot key combination used
to uniconify DOpus that it allowed it to reappear after it disappeared, or
that it never disappeared? If it's the former, then it's a good workaround
for now, but there would still me a bug, since it's not supposed to
disappear at all.
Thanks.
Dom Fontana
<– Sent from New York via AutoPilot –>
I wasn't using the default configuration I was using my old defaults
from the previous version of Opus. My old hot key combo worked for a while
then stopped. When I changed the combination it started working again and
has been OK since.
Dennis ….on AutoPilot