#Star SG-10 Printer
3 messages in this thread
Has anyone here used a Star SG-10 printer with an Amiga, AMAX, or XT-BB?
What printer driver did you use? How was the print quality? How about
speed on graphic dumps?
No witty signature, just: Ernie Gorrie, Port Coquitlam, B.C., Canada.
Ernie,
I used one of the drivers from Library 7 when I was using the Star SG-10
printer. It worked quite nicely except that I was never able to get the
spacing quite right. If I printed multi-page documents, they would be gin
to run off the bottom of the page after three or four pages. I didn't do
much with graphics at the time, so I cannot tell you about that.
.Betty
Ernie,
There is a printer driver for the SR-10 that I did a lot of work on to add
a number of features and make 1.3 compliant. From what I can tell, this
printer has the same command set as the
SG-10 (a person sent me a copy of
the SG-10 manual dealing with the commands), so the driver should work
pretty good with your printer.
It should be in the printer driver section. Do a browse with my PPN
(76475,1146) as a key (BRO/DES/KEY:76475,1146). Ah, I took a look at my
copy of the library catalog. The file name is SR10.ARC and it is 10163
bytes long. Be sure to read the doc file in the archive! Very important.
73, Kelly