#Spectrum Help
2 messages in this thread
I need help installing an EGS 28/24 Spectrum The software install
seems to proceed normally until I reboot. During the reboot, I get an
error message saying "No LEGS installed". I answer "OK" and I get the
default Amiga screen. When I try to run EGS-DisplayAdjust, nothing
happens (ie no program starts up…no apparent reaction at all). I
can run several other EGS programs such as ScreenModes, etc and
successful use those but I can't do much else. I've tried deleting
everything, restore boot partition and re-doing software install with
same result. My hardware setup…A2000 w/GVP 040 accelerator. NEC 5FG
(with adaptor plug for cable) and FlickerFixer2 looping into Spectrum
input (ie one monitor) HELP !!!
Thanks
Richard Nichol
Richard,
The "NO LEGS INSTALLED" means that the hardware is not found. This could be
because the board is not properly installed or another board is preventing the
Spectrum board from autoconfiguring. In an A2000, you need to leave 2MB of
autoconfig memory space open for the Spectrums video memory to configure. The
other results described are consistent with the board not being present.
Try re-installing the board. Remove any other boards except for the Spectrum
and the G-Force board. Use the SHOWCONFIG program that comes with Workbench to
see if the board is there. The manufacture code will be 2193 and there should
be two entries.
GVP TECH