#3DS in NT
5 messages in this thread
Hi, Jonas, I was reading about the '3DS working in NT' message from Maritn
Foster. I recently read the latest aritcle from Planet STudio, which says that
there is an unoffcial way to use 3Ds inside NT, but you need a special Rainbow
Driver in order for NT to access the Sentinel Pro, you have any clue of how I
can get that driver?
I'm currently using R4c1, NT 3.51, P90, and 32 megs of ram.
File Info for 3DS4-NT.ZIP
Section: HWare/OpSys/Video Contributor: 70303,1363 Size: 82424
Submitted: 6/24/95 Type: Binary Accesses: 235
Title: Running 3DS R4 Under Win NT 3.51
Keys: 3DS WIN NT DRIVERS
This ZIP file contains instructions and Sentinel Pro lock drivers for running
3D Studio
R4 under Windows NT 3.51. These instructions are not fully
tested and are provided "as is". They DO NOT represent Autodesk support for
running 3DS R4 under Win NT.
Thanks very much, now I'm going to run 3DS under NT, and screw my computer UP!
Yeah!!!!!
<< I'm going to run 3DS under NT, and screw my computer UP! >>
Well, if that's your wish…
HI, 3DS worked under NT, but not very impressive. I just got Win95, and 3DS
runs great under it. I'm also going to install NT again over 95, so I can have
a dual boot to either 95 or NT.
OK, I got the two cool operating system going now, they all did a great job of
running existing sofwares. But I couldn't get Animator Studio running on either
one! When I install 95, it overwrited the old windows, so I can't use the old
one at all. Do you have any clue? Thanks very much.