CompuServe test bed

CompuServe Thread

Autodesk Software Forum · Autodesk 3D Studio

#3D Studio Manuals

8 messages in this thread
#56098From: ron kalasunasSep 3, 1993 2:59 PM
>> Why not just upgrade to version 2? Greg: How would I go about upgrading to version 2 or 3 and around what would that cost? By the way, When I found my origal 3D Studio disks they were flooded with water from the hurricane but I kept them anyway. You can almost read the labels. Thanks
#56144From: Sep 3, 1993 11:55 PM
Ron: >> How would I go about upgrading to version 2 or 3 and around what would >> that cost? All you need to do is to send us your original #1 disk (assuming it's readable enough after the flooding!) and we can handle the upgrade for you. The cost of the upgrade from Release 2 to Release 3 is $497, I haven't seen any prices from Release 1, though. Anyone from Autodesk know the pricing of the upgrade from R1 to R3??? Greg Pyros
#56319From: ron kalasunasSep 5, 1993 4:20 PM
Thanks for your help Greg, I appriciate it. Ron
#56373From: Sep 6, 1993 1:36 PM
Ron: >> Thanks for your help Greg, I appreciate it. Any time! Greg Pyros
#56502From: CSA/CASep 7, 1993 2:04 PM
Greg, The upgrade from EITHER release 1 or release 2 is $497 list. Release 1 folks will also receive the protection block when upgrading, absolutely FREE! <g> Kevin Krell – Computer Support Associates
#56514From: RACHID MOLINARYSep 7, 1993 3:14 PM
What is the protection block?
#56693From: CSA/CASep 8, 1993 12:12 PM
Rachid, 3D Studio release 2 & 3 have a hardware protection lock (or 'key', or 'dongle' or whatever you want to call it) that must be attached to a parallel port on the system running the 3D Studio interface. Kevin Krell – Computer Support Associates
#56594From: Sep 7, 1993 11:58 PM
Kevin: >> The upgrade from EITHER release 1 or release 2 is $497 list. Release 1 >> folks will also receive the protection block when upgrading, absolutely >> FREE! <g> That is quite a deal! I didn't realize that they were both the same $$$! Thanks for the info, Greg Pyros