#Need help with disk 6
4 messages in this thread
Greg,
This probably isn't the best way to go about getting help, but I don't know
another way. Using the Flame.axp on disk 6 i often get the error- exp mesh op
failure- object not ready- (that's not verbatum but i can't make it pop up on
cue) Any help you can give me would be appreciated.
Jason M. Whyte
5 W Graphics, Inc.
76072.1043
Jason…
Are you checking for "secondary motion data" being created before rendering?
One has to go into object attributes, then flame dialog box, then exit to
create secondary motion.
This may not be your prob,…but it seem a lot of people forget it.
Hope it helps…Kev.
Jason:
>> This probably isn't the best way to go about getting help, but I don't
>> know another way.
This works, but try addressing a message to ALL or to someone responsible for
the program in question.
>> Using the Flame.axp on disk 6 i often get the error- exp mesh op
>> failure- object not ready
Flame.axp was written privately by the Yost Group, and any of them or possibly
Jonas will be able to help. I haven't seen the error message you are referring
to, so I'll have to pass this one along! Jonas?
Greg Pyros
Hi Jason,
<< Using the Flame.axp on disk 6 i often get the error- exp mesh op failure-
object not ready- (that's not verbatum but i can't make it pop up on cue) Any
help you can give me would be appreciated. >>
This is a message I have not seen before. Does this occur on all of the
examples that ship with the product?
jonas[adesk]