#COLORMODE=? FOR B&W?
10 messages in this thread
I have one question. Does anyone know what the tooltype should be to have
PPage load up in Black & White mode only? Right now it comes up in
color and the tooltype I've been changing is
COLORMODE=COLOR
I've tried changing that to BLACK_WHITE, B&W, BLACK_AND_WHITE, etc., but
it always loads in color mode.
Any help with the problem is appreciated, thanks,
Christopher
COLORMODE=BW
Jeff Walker.
Jeff,
<<COLORMODE=BW >>
Thanks! It worked like a charm. Know any others that aren't documented,
like maybe Wireframe OFF? 🙂
Thanks again,
Christopher
The easiest way to have ProPage load with all your settings just the way
you like them is to open a new blank page, set up all your prefs and then
save the blank page. Then "run" this project instead of running ProPage.
Jeff Walker.
Jeff,
Great idea! Why didn't I think of that one? 🙂
Of course I could save it as a template, and open that file.
I don't know about others but I miss not having updates to PPage.
Well, I sure hope that someday (soon) Pagestream meets up to its expectations!
Like RSN!!!!
Chris
Some of the settings that are listed for ProDraw/ProPage but not the other work
in the other. I don't remember exactly which way, which commands, but I
remember trying a few one time that worked.
/ / / //ANDRE
Andre,
Thanks for the info, I'll check my PDraw manual(s).
Chris
Chris..
There is a utility called ToolTypeWatch which will list tool types when
you open an application. I have used it with both 2.01 and 3.1 ADos. It
may be available on CIS — I don't remember where I found it.
Regards,
Bob Carter
Quilters' Fancy, Toronto
Robert, and Chris…
I uploaded Dostrace and Icontrace recently, these will help you also
tracing tooltypes.
Lieven LEMA
On Autopilot from Belgium
Lieven…
Thanks for the info. I'll check them out….
Regards,
Bob Carter
Quilters' Fancy, Toronto