#Emplant/MultiScan?
4 messages in this thread
Does anyone know if there is a MultiScan driver available for the Emplant
MAC emulation. I have a very nice SuperVGA monitor that works great with
my A4000 in MultiScan mode. Now that I have the Emplant I would like to
use this monitor with it. If there is no MultiScan driver for the Emplant
could I get a flickerfixer for the A4000 and thus be able to use AGANTSC
on my SVGA monitor? I suppose if this is not possible then my only
alternative would be to get a new monitor that syncs 15-31. Correct?
Advice/suggestions appreciated.
Regards, Marty
"When the eagles are silent the parrots begin to jabber"
-Sir Winston Churchill
????
I'm not really sure what you're trying to say here. But, if you have a monitor
that works with your A4000 in the AGA mode, there should be no trouble using
the sames screen mode with Emplant.
The Emplant comes with the standard driver for AGA. There should be no
problem. You don't have to get any extra "Multi-sinc driver" or filcker fixer.
Just go ahead and try it!
Hiroo YAMAGATA
My A4000 works with my Panasonic 1381i monitor in AGA MultiScan mode. This
monitor does not sync at 15mz; so any attempt to run the A4000 in AGA NTSC
mode on it is useless. The video drivers which the Emplant supports do not
include AGA MultiScan.
-mls
"When the eagles are silent the parrots begin to jabber"
-Sir Winston Churchill
If you turn on MODE PROMOTION, all Amiga screens will be promoted to MultiScan.