TO: ALL WHO CAN HEAR
I HAVE A GATEWAY 2000 PENTIUM 60 (P5-60) WITH A VIPER PCI AND 40 MEGS OF
MEMORY. I AM USING A NEC 4D MONITOR.
THE PROBLEM:
I CANNOT GET THE VIPER TO DRIVE THE NEC 4D IN 3DS STUDIO R3
I HAVE TRYIED USING THE THE VIPER IN VESA MODE
I AM USING THE NEW 3D STUDIO DRIVERS(OFF CSERVE) TO RUN IT AS A VIPER (9000)
RESULT OF PROBLEM :
THE MONITOR GOES MILY, OR I GET 4 INCH BAND OF WHITE DOT( IT IS A TEXT SCREEN
OUT OF SYNC, YOU CAN SEE IT SCROL WHEN YOU ASK FOR A DIRECTORY)
COULD ANYONE TELL ME WHAT TO CONFIGURE THE MONITORS (INI?)SETTINGS TO? IT
RUNS GREAT UNDER WINDOWS DOS ETC.
I have the same system, I have to use 3DS 3.0 with the vesa drives. However, I
have a problem in the materials editor. There I can only get 640x480x256
resolution.