CompuServe test bed

CompuServe Thread

Corel Forum · CorelSCSI!

#Unable to read config

2 messages in this thread
#85623From: Raymond RakNov 10, 1993 10:21 PM
Laszlo I discovered the problem. It was with the the Adaptec card not being set to the 330H port address. I needed a "/p=<port address>" on the line loading the driver if the address was something other than the default. Thanks for the tip. Raymond
#87143From: Bryan ShearerNov 18, 1993 10:33 AM
Raymond, If you read the posted apology you would understand the tardiness of the responce. No problem! Laszlo