Amiga sale Update#2
8 messages in this thread
I can repost the listing, no problem. As far as equipment is concerned, we have
records that show what we own and what stuff is loaned.]
I must strongly remind you and any that might be reading this thread that we
are not selling loaner equipment, nor have we sold any nor will we sell any
Chris Edgin
ERI tech.
I am having a problem loading Morph and Morph.020. I have them in the same
drawer as ADPro 2.5. When I click on the icon, the program starts to load and I
get a window with the following in it "LOW ON CHIP MEMORY" and the program
fails to load. If I start Morph.020 from a floppie disk, it load without a
problem. Why?
System:
Amiga 40/040 (WARP 4040) 2 megs chip RAM. 20 Megs FAST RAM. 120 and 540 Meg
hard drives. PAR, TBC-IV, Opalvision Main Board OS 3.1 At least 1.8 megs of
CHIP RAM free when I get the LOW CHIP RAM requester.
Jim R. Ollick on a Warped 4000/040/40
Using AP 1.75 from Bergenfield, NJ
Well, I cannot say woth any certainty what might me cause the 68k version to
complain about chip memory when the 020 version does not. I will havce to
confer w/ the programmers to get any sort of answer about that.
Chris edgin
ERI tech.
Sorry, I may not have been clear enough but both versions come up with message
about not enough chip memory when launched from my hard drive. If I run them
from a floppie disk (the original disks), I have no trouble.
Jim R. Ollick on a Warped 4000/040/40
Using AP 1.75 from Bergenfield, NJ
That IS stange (:-/
Have you attempted to reinstall and do you also have ADPro?
Chris Edgin
ERI tech.
Yes I reinstalled the software and I do have ADPro 2.5.
Jim R. Ollick on a Warped 4000/040/40
Using AP 1.75 from Bergenfield, NJ
In what oder did you install the two program? i.e which one got installed
first?
Chris Edgin
ERI tech.
If you mean from the begining, I had installed ADPro version 2.0.3 (I think
that is the right number) first, then bought the MorphPlus package and
installed it sometime later. After that I bought the upgrade to ADPro, 2.5, and
installed it. After having the problem with Morph020 I re-installed the
MorphPlus package.
Jim R. Ollick on a Warped 4000/040/40
Using AP 1.77 from Bergenfield, NJ