CompuServe test bed

CompuServe Thread

Autodesk Multimedia Forum · Autodesk 3D Studio

assign shapes from acad

6 messages in this thread
#141274From: ben barronDec 12, 1994 12:28 AM
Hi I can't bleave this I dxf in some plines from acad to 3ds acad sead thhat were closed and joined in 3ds I ATZ ASSIND THEM some of them were not good shames so i zoom in to have a look thay loog look good to me and then when zoom in I could assign them ( I not smoking dope ) so what is going on ??????????????? Ben
#141305From: Jonas Ruikis [ADESK]Dec 12, 1994 8:59 AM
Hi Ben, << Hi I can't bleave this I dxf in some plines from acad to 3ds acad sead thhat were closed and joined in 3ds I ATZ ASSIND THEM some of them were not good shames so i zoom in to have a look thay loog look good to me and then when zoom in I could assign them ( I not smoking dope ) so what is going on ??????????????? >> I don't understand. Can you repeat the question? jonas[adesk]
#141361From: Nik Grant [adesk]Dec 12, 1994 12:29 PM
Can you send us one of the culprits? We can check it out here and let you know.
#141485From: ben barronDec 12, 1994 10:22 PM
Hi Nik yes I wilsend you a disk or drope it of at autodesk but I will try this first with acas-13 if its ok then I may just let it go Ben
#142695From: Stuart NicholsonDec 19, 1994 7:10 PM
Have you set your units in 3D Studio to be the same as those in ACAD (eg cm-cm etc)
#142757From: ben barronDec 19, 1994 11:45 PM
Hi Stuart yes the units aer the same the problem has to do with the mirroring in acad allso I have just fond that some of the lines are duble Ben