#Rendering with PAR & AM
6 messages in this thread
Dear Hash Inc et al,
I have a P90 with a DPS Par card installed. From the render module, I am
trying to render directly to the PAR hard drive. After it renders one frame it
trys
to save it and it comes back saying "Unable to save file" Do I have to render
to a Dos drive first?
Everything works fine when I render to a Dos drive and this brings me to my
next
question: I have the output of my PAR hooked up to an NTSC monitor. THe out
put looks pretty bad. Is there any recommended way of setting the PAR up fro
AM that I am not aware of. ANy suggestions will be greatly appreciated.
THanks,
ALEX IMBASTARI
800 576 7472
Alex, A:M unfortunately does not support rendering directly to a PAR drive, you
must first render to a DOS drive, then move the files… Version 3 will support
direct to PAR drive rendering.
As for your output problem, I'm afraid I don't have any suggestions, that's how
we have ours set up and the output looks as good as cable broadcast… perhaps
someone else will see this and have something to offer.
Steve, Hash Inc.
Alex,
This is a public forum. Your Phone number in the signature is a BAD idea…let
us know if you wish it moved to a safe area of the forum by replying to this
thread. It's your call.
Bruce Herzog
Forum Staff NY 13-Feb-95 at 3:23p EST
THanks for the heads up. Won't do it again. So far haven't had any nasties
coming in.
Alex Imbastari
No Problem…We can still move it if you wish.
Bruce Herzog
Forum Staff NY 15-Feb-95 at 5:30p EST