CompuServe test bed

CompuServe Thread

Forum unknown · Talk to the Trade

#Silver

11 messages in this thread
#89903From: Larry HeiserOct 18, 1987 12:48 AM
Has anyone else used this program. I can't get the tutorial to produce what I would call a decent result; not only that It locks up the machine and I have to reboot after showing the picture. Obviously the manual is next to useless, but there's got to be a way to get some information. Is stan still around? Larry
#89904From: Steve AhlstromOct 18, 1987 1:03 AM
After playing with it for just a very short time, the program seems to perform as stated in the manual. After you show a picture and want out, try hitting the esc key.
#89949From: Larry HeiserOct 18, 1987 12:15 PM
Thanks. Did the One Ball tutorial produce a decent looking sphere? I could have done better with Deluxe Paint II. Larry
#90030From: Rodney SomersteinOct 18, 1987 11:28 PM
Larry, I managed to produce a decent looking sphere with no problem. If you are having any specific problem, try calling tech support at Impulse. They were very helpful even though they didn't have my registration card yet. Rodney Somerstein 73167,2165
#90268From: Larry HeiserOct 20, 1987 12:33 AM
Ron: Thanks, I'll call them after I've played with it a little more. Larry
#90268From: Larry HeiserOct 20, 1987 12:33 AM
Ron: Thanks, I'll call them after I've played with it a little more. Larry
#90030From: Rodney SomersteinOct 18, 1987 11:28 PM
Larry, I managed to produce a decent looking sphere with no problem. If you are having any specific problem, try calling tech support at Impulse. They were very helpful even though they didn't have my registration card yet. Rodney Somerstein 73167,2165
#90046From: Steve AhlstromOct 19, 1987 1:16 AM
The One Ball tutorial did produce a reasonable sphere hovering about 1 inch above a the ground. Nothing earth shattering. I was about 3 hours into the multi-object trace when I found another program that runs on the 1000 and takes out the 2000. I'll give the multi-object demo a try again soon.
#90046From: Steve AhlstromOct 19, 1987 1:16 AM
The One Ball tutorial did produce a reasonable sphere hovering about 1 inch above a the ground. Nothing earth shattering. I was about 3 hours into the multi-object trace when I found another program that runs on the 1000 and takes out the 2000. I'll give the multi-object demo a try again soon.
#89949From: Larry HeiserOct 18, 1987 12:15 PM
Thanks. Did the One Ball tutorial produce a decent looking sphere? I could have done better with Deluxe Paint II. Larry
#89904From: Steve AhlstromOct 18, 1987 1:03 AM
After playing with it for just a very short time, the program seems to perform as stated in the manual. After you show a picture and want out, try hitting the esc key.