This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (60 messages)
Thanks for the tip I will try that number, the number that was listed in the docs seems to be out of service or disconnected. John Lemoine 75320,143
Kelly, it tells you what Rev it is in the docs that were included in the Archive it came in. The first version I have came from Compuserve and was version 1.3. It also will tell you what version it is if you start mackie from the command line. (mackie…
I dont care very much what happens regarding Tetris or its clones all I want is version 1.4 of Mackie that unfortunatley is on the disk that has one of these Tetris clones, so it is unavailable until the legal stuff is sorted out. If anyone has it could they…
#Mackie 1.4
Message #103265
Hi Betty I am just writing to remind you about uploading Mackie 1.4 from Fred Fish disk 305. I have found out more about the reason why that disk and several others have been temporarily pulled. Apparently the American distributor of Tetris has launched legal action against programs that look…
Hi Phil When I built the Frances board I put the CAS hack in so I dont know whether it would run properly without or not. I got the 74F21 at a local supplier (Active Electronics which is a chain here in Canada subsidiary of Future electronics) most normal parts…
#FRANCES problem
Message #96072
Hi Phil I am not sure what your problem is but, you might try what I did. I have the pals grounded together with one piece of wire that then runs down to the large ground plane beside the expansion connector beside the 68000 socket. I also have this wire…
32 bit Ram Testing
Message #95145
Hi does anybody know of any good memory tests in the Libs. I want to do a long term ram test on my Lucas/Frances 32 bit Ram board. The ram test supplied with Lucas/Frances does not allow continuous looping ie. running over night. It seems to just test to make…
#Silver 3.0 SV
Message #11938
Getting back to the problem I was having with multiple light sources, I am having trouble reproducing the problem. It appears that it probably was due to ambient settings set too high.(the manual warns of this but fails to indicate what is too high) unfortunatley there are many problems like…
#Siler Lamp troubles
Message #11640
Thanks for your help with my problem getting my manual for Turbo Silver, I talked to Mike Halvorsen and I got my Manual a week later, Thanks Again. I seem to be having a problem with light sources in Silver, I am rendering a simple scene with only 1 object…
Lucas & More Memory
Message #58018
I would like to tell anybody out there who is using a Lucas board that it is possible to add on an outside expansion box to the A1000 for more memory etc. I am currently running an A1000 with a Lucas 68020/68881 board running at 16Mhz, also I have added…
Page 2 of 2