This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (163 messages)
>Rachel's people are low resolution with extremely low face counts – that means >you can use lots of them if you don't need closeup detail or movement. Thanks, I will contact here !
>Rachel Rosenthal, sells People meshes, leave her a message, 71064,1654. Thanks, I will !
>Martin – In answer to your question, by using tconfig.exe and setting it for >512×486 you're putting the Targa in gamma correction mode even though your >setting is a 1.0 which is neutral (as opposed to off). Its still going through >the circuitry. I havn't tested the 512×486 resulotion as…
#People with clothes !
Message #63957
I need people-meshes for 3DS with clothes ON ! 🙂 I have seen that there are a couple of companies talking about some people meshes in this forum. Please contact me as soon as possible !
If I understand you, will tconfig with gamma set to 1.00 do gamma correction on a Targa+ 16/32. I use tconfig on my targa+ card with gamma set to 1.00, and get a gamma correction at 2.10 in 3DS. As I see it the gamma 1.0 in tconfig is the…
#Disk to VTR speed !
Message #62844
I have a DQ-422, Targa+ and are doing "Disk to VTR" recording to a SONY BVW-75P Betacam SP with preroll 3 sec. I get recording speed of 12 sec/frame, 5 frames/minute or 300 frames/hour. Is this fast/normal/slow ? Does somone else have other hardware that has hihger performance level !?…
#IPAS and C++ ?
Message #60755
Will there be support for C++ in the IPAS Toolkit for R3 ? I'm not a C++ programmer yet, but I have another project now where I can choose between C and C++. Soo my question is, can I use C++ in IPAS programming in the future if I struggle…
SXP:data norm_pert ?
Message #59780
I think I know that the orientation of the norm_pert vector makes the bump go in or out but I wan't to know what the lenght of the norm_pert vector does for the bumpmap !? Is it the stenght ? If so what is it meshured in ? The only…
>I can answer part of the question: 3DS3 is being shipped as an Intel version >only. Unresolvable compiler problems has forced this. The good news: if you >have a Weitek 486/33 or less, then an R2 Weitek version of 3DS should not >render any faster than the R3 Intel version…
#IPAS & R3 with weitek ?
Message #59400
Will 3DS R3 and IPAS-programming kit support weitek ? regards, Martin I have asked this question before but didn't get any answer ! 🙂
Thanks John for your reply. Do you have additional information for that SoftVTR, where to purchase it or a contact on Compuserv. ? I will get in touch with Bill Stickney about V-LAN ! Martin Enthed
IPAS programs ?
Message #55729
I would like to know if someone else than YOST GROUP that sells IPAS programs ? Name : ? Description : ? Price : ? Where to order : ? Thanks !
VTR Controlers ?
Message #55728
I would like to know if their are any other VTR controlers out their than DIAQUEST ? Name : ? Price : ? Supported VTR's : ? Compared to DQ : ? Where to order : ? Thanks !
Page 4 of 4