This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (9 messages)
#AutoCad Dealership
Message #33803
Malcolm — Call who back to discuss what? Melanie
Thanks Katinka! My mind is at ease now … . –Thanks again! Melanie.
Hi Katinka … yes! I have the serial #. It's 01-833551. We turned in disks 1-3. –Thanks! Melanie.
#AutoCAD R9 Order
Message #22052
Hi Jamie … Is there a way to check on my order for the upgrade to release 9 from 2.52? I ordered it thru a local dealer on Mar.16 and they said it would take about 3 wks. When I call and inquire about it they just tell me, "well…
Thanks John … you're right, it is slow but where there's a will, there's a way (for now, anyway). –Melanie
Thanks John … you're right, it is slow but where there's a will, there's a way (for now, anyway). –Melanie
Plotting w/Autosketch
Message #21384
Thanks to both you and Steve for the help with my Autosketch plotter problem, i.e. Autosketch bombing out in the middle of a plot. I'm using an HP 7470 single pen plotter. I checked the cable and it's configured properly. The MODE command that was being used was: MODE COM1:12,7,E,1…
#21202-
AutoSketch ?/wishes
Message #21309
Dear Duff, Thanks! Could you make that two votes for each wish? Both of us would love to see these enhancements … in the meantime, I read Jamie's reply and will start to get creative in my technique soon … THanks — Melanie
Jamie — Thanks! A lot of these techniques you mentioned are neato and in some distant way, it may have occurred to us but we're just a bunch of lazy people who'd rather push a mouse than use a pencil… THanks again! — Melanie