#Bridgeboard Info
20-Dec-87 01:09:45
Sb: #99013-#Bridgeboard Info
Fm: Don Curtis/SYSOP 76703,4321
To: Mark J. Morales 72307,2503
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
Yes…the Shared Utilities (JLink, ARead, AWrite, etc.) don't
understand it when Janus is moved from E000. The BridgeBoard WILL work
just fine thou. I had to move Janus off E000 temporairly to get an
expansion board to configure properly. The shared utilities were the only
thing I found that didn't work right.
OH…I did find that moving it to A000 caused it to ignore my expansion
board (which had it's ROM addressed at C800) as if once it's hit the Janus
code…it quits looking for additional ROM tags above Janus' address
location. This is a guess. When I moved Janus to D000 then my expansion
card ROM was recognized and it booted. I then moved the paging area of the
expansion card off E000, re-set Janus back to E000 and everthing has worked
perfectly since then.