CompuServe Messages

I would select all of the far end vertices of the boards to be cut, except the vertices that will stay put on the first board to be cut (clear? <g>). Then move/vertex (selected) to get the appropriate angle for the first board… the other boards will now be the same length as the shortest length of the first board. Select none, then select all of the end vertices except the "long" vertices of the second board, then move/vertex (selected) again, the same distance as before to keep the angle the same. Do this for all of the boards. A 45 degree angle should be easy… either do the math to determine how far to move the vertices, or use the disply/tape. You can align one end of the tape to the far corner of the first board, move the other end so the tape is at 45 degrees, and see where it intersects the opposite side of the board. That is the point at which to move your vertices the first time. Paul S.