#Chaos under DESQview
I just got CHAOS: the Software, and would like to run it under DESQview
2.41. I have DESQview set to expect Chaos to write graphics information
directly to screen, and to virtualize the video. The Chaos batch file
starts, Metashell is loaded, and the Autodesk logo appears, with the
message "Please wait while program loads." The logo changes from blue to
yellow. But nothing further happens. If I press Esc at this point, I exit
from the Chaos batch file. The program runs fine (if somewhat slowly at
some points) on my system, a 25 Mhz 386 (no coprocessor) with VGA and a
multiscan monitor. Thanks for any advice you can give. I submitted this
question a couple of weeks ago, and was advised to resubmit it when
everyone was back from the holidays.