#AutoSketch
05-Apr-88 08:57:46
Sb: #21497-#AutoSketch
Fm: Clark Perkins 76676,2053
To: Jamie Clay [Adesk] 76703,4204
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
Jamie — The EGA card is THE ™ HEGA from PC Network, a little
over a year old. A review of the Documentation shows that the card is
supposed to be capable of two 32K grapghics pages, or 64K of total display
memory, as you suggested. Running Norton SI (v.3.1) reports only 32K of
display memory.
I rechecked the settings and booted up AutoSketch in both CGA and
EGA modes: It seems to work fine in both modes (I recopied it and reset
the parms each time). I don't have any memory enhancements installed at
this time, although I do have a Rampage 2Mb board on order. If the EGA
card is using system memory will that become a problem? Can I redirect it
to the Rampage later?
Thanks,
Clark