#WarpEngined 3000
Yah, I guess the termination problem is because the drive was terminated when
it was on the 3k's SCSI bus. So I do have terminators on my motherboard.
Whheeee!!!!
>>My comment about changing the A3K controller ID was only if you were going to
run both controllers on the _same_ bus.<<
Huh. I didn't even know that was possible at all.
I'm *REALLY* hoping that the problems I'm having are because the drive is
terminated, the WarpEngine is terminated, and the tape drive is terminated…
except I just realized that the tape drive isn't attached for now, so there
shouldn't be a termination problem. 🙁 It just goes to show, as usual, that I
have no idea what's going on.
Anyway, turned out that MacroSystem sent me the connector for the 4k's
knockout! So they're sending me a new one. 🙁
Mr. Zombie