Bridgeboard Display
23-May-88 11:44:59
Sb: #125650-Bridgeboard Display
Fm: TIM TRIMBLE 76306,1115
To: Richard George 76625,1460
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
There is also a command in DOS that you need to enter for the type of screen
that you are using. If you boot the bridgeboard in mono mode then once you
are in DOS type MODE CO80 and then go to the workbench and run the IBM Color
Icon. You then find the cursor and prompt on the CGA screen. To switch back
to the mono screen you will have to type MODE MONO (in DOS) and then flip
back to the Mono screen. Look up the MODE command in the DOS manual that
comes with the bridgeboard and it will explain in more detail.