#GVP Hardcard Problems
I am having a problem with a an older GVP 40 meg hardcard in my A2000 (rev.
6 motherboard) and am hoping someone here can help me, or at least point me
in the right direction:
When I turn the computer on and the hd attempts to boot-up, I get
a "volume workbench has a read-write error" message, and when I click
"retry" I get "Unable to load Sys:GVPscripts/tstGVPscsi: file is not an
object module".
I get the same results when I try a three-fingered salute. However,
when I actually turn the computer off and back on at this point, it boots
without problem.
This has been going on for at about the last 5 months.
I have checked the cable for loose connections where it plugs into the
card and the drive and all seems in order. The card itself seems properly
seated in its slot.
I have used diagnostic software to see if there actually is a
read-write error and found nothing.
I am stumped and at a loss as to where to go from here. Anyone have any
ideas?