VLab Digitiser Board
23-Apr-95 18:27:05
Sb: #46460-VLab Digitiser Board
Fm: Roger C. Van Duyn 72437,3536
To: Derek Austin 100531,1412
Hey Derek,
I have a VLab Y/C board and experienced the same behavior as your board a
few weeks ago. There may not be anything wrong with your board at all, but
the software settings may need to be changed.
Look under the CONTROL menu. Then the SCAN submenu. If there is a
checkmark by the MINIMIZE NOISE option, then that is your problem! Turn
minimize noise OFF for moving video sources. That choice is only for a
still video source.
VLab boots up with the software settings last used. I'd been grabbing
stills one day. The next day when I went to grab from a video tape the
board acted just the way you described. It threw me for a loop for a
while, but eventually I remembered about the MINIMIZE NOISE function and
turned it off.
I hope this solves your problem.
Roger C. Van Duyn // on AutoPilot