GVP A530 turbo
I have an A530 Turbo. I was performing a low level format on the Maxtor drive
prior to a bad block remap after an unending string of checksum errors. A
power outage interrupted me. When I rebooted the system, the A530 would not
mount since the software on the drive had been wiped out. I retrieved the
mountlist and ran Expert Prep. Although the software recognized my hard drive
and my CD rom on the SCSI chain, it referred to my hard drive as a 0 mb device
and all information concerning it was lost. All the fields were ghosted so I
could not enter any information into the program for partitioning or anything
else.
Simply put, I can't access the A530, the hard drive or the SCSI chain. It just
isn't recognized. Will the AmigaDOS mount command cure this or is this a
software problem? If this appears to be a hardware problem, please advise.
Thank you!
~~~~sailing on autopilot~~~~
jeff @ lamplight productions