HP ColorPro Plotter
17-Jun-86 21:34:43
Sb: #23253-HP ColorPro Plotter
Fm: Andy Levy 72767,1237
To: Aegis Development 76067,2500
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
1. I did try using SMOOTH but it curved the rectangle along the entire side.
I want to maintain parallel sides for almost the entire length and only round
off the very corners. I'm used to the 'round corners' command in MacDraw that
allows radiusing of a specific value — how can that be done? 2. Interesting
ability (not necessarily a bug): It is possible to enter a null string as a
Part name and it is accepted — and future attempts to do it again give a
'Part in use' msg so it actually has been stored under the null string. It
might be interesting to see what happens if an attempt is made to write such
a Part to disk… –APL