GadToolBox
Does anyone out there use GadToolBox regularly? I have used it a good bit,
but only recently checked out my source code with ENFORCER and I found that
the code that was written produced many hits.
Just to check, I tried ENFORCER on GadToolBox itself and found that when I
selected my screen mode and the program began, I got about 8 enforcer hits
(long reads) and it was consistantly hitting after that. I am not an
advanced programmer so I really can't do much with the output of enforcer,
other than realize there is a problem.
Does anyone have any hints about possible problems in the output code so
that they can be corrected by hand? I am using version 1.3, is there a
newer version out there?
Thanks,
Bill
– via Whap!