#Adding a face??????
Hello
While working on a project, I ran into a relitivly simple but frustrating
problem.
I used "FontStudio 3D" to create some beveled text for a logo.
FontStudio exports as a DXF file.
After a test render, I noticed that one of the letters in the logo was missing
a face in front ( and the same face in the back) so I could see through the
letter.
I tried using Face – Build to add the missing face in the front, but it was
very hard to get the face to fill in the hole. It kept putting corners of the
face accross the letter so I would end up with the face attached to the front
at one point and the back at another. Also I couldn't make the face exactly fit
the hole.
What is the best way to do this.
Thanks
David Camp