CompuServe Messages

Dan, Some possibilities are: If you have an accelerator you must run either "Enforcer Quiet" or "CPU nodatacache" BEFORE executing Binddrivers. Failure to do that will usually result in the BB not seeing the virtual drive. A second possibility is to check in PCPrefs to be sure you have the Janus memory segment set to D000. One or both of these can cause the problem you have. You might also check in the PC directory where Janus was installed on your Amiga and check to be sure that none of the files have names with leading blanks. In the installation files which had names similar to those of the old Janus get named with leading blanks. Thus, the may not execute properly during the bridgeboard setup. Lastly, when you boot the BB from floppy, run BBSetup and be sure you have your CMOS settings correct. The two entries for Hard Disk 1 and 2 should be set to NONE.