#Fatter Agnus and A500
27-Aug-89 01:19:52
Sb: #63440-#Fatter Agnus and A500
Fm: Don Curtis/SYSOP 76703,4321
To: Rodney Somerstein 73167,2165
Move the jumper at J101 from pins 1-2 to pins 2-3. Cut the trace
between the two pads at J500. NOTE: the trace is VERY small and VERY close
to other traces…if you slip, you may end up with a DOA A500. CBM
reccomends a small sharp knife like an Xacto for the cut…I cheated…I
used a small drill bit (#65) in a hand chuck (like a jeweler's screwdriver)
and simply turned it a couple of times and the trace was cut. Obviously,
if you use my method, you only turn the drill far enough to cut the
trace…not put a hole in the motherboard! One or two twists by hand is
plenty.