Strange A3000 Disk Probs
31-Jul-94 17:56:36
Sb: #157933-Strange A3000 Disk Probs
Fm: Jay Truesdale 72176,3565
To: Brian Bartlett 72037,570
>> I am deeply concerned that your system died a second time after a
>> full backup and restore. I would second the Bad Block Remap as well.
>> However, if this fails, you really need to start looking at a
>> hardware problem.
I'm not so sure that the bad block remap is the right thing to do for a Quantum
SCSI drive as according to the drive manual, the drive takes care of that sort
of thing.
>> a controller problem, very likely and easy to diagnose,
Well the other (boot) drive still works OK.
>> or a hard disk problem, extremely likely and hard to diagnose.
More likely I think. If I have to I'll plug it into my PC and exercise there
for a wile.
Yesterday I had AmiBack Tools fix the disk partition. I used the computer for a
while and it was fine. I ran ABT before I shut off the machine and all was ok.
I just turned the machine on today and it reported more problems with the
suspect partition. Very strange.
Then as the machine warmed up I noticed that the video got worse and worse,
i.e. all of the vertical lines started looking jagged in a horizontal
direction, kind of like a column of "Z" characters. Makes the screen a bit
difficult to read.
I am going to take the machine to work tomorrow and check out the power supply
with a volt meter and a 'scope and see what's up.
-J