#AEGIS DRAW
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
Here's the PlotDriver file I've been using for the DXY-800 (I still tweak
the dotted line pitch once in a while, but the file is functional).
42586
254.0 13.77 10.23 .015
1 8
"H"
"H"
"M" "," ""
"D" "," ""
"J" ""
"L0"
"B12^ML1" /* the ^M, naturally, is CTRL-M */
"B6^ML1"
"B3^ML1"
"B1^ML1"
"B12^ML1"
"B6^ML1"
"B1^ML1"
"B3^ML1"
"B2^ML1"
This has worked fine with the Plot Unscaled function; I'm still at the head
scratching stage on getting Plot Scaled to work properly. BTW, recommend
that you use the parallel port, rather than the serial (nice to have a
choice), as I'm not sure what default values are for word
length/parity/stop bits under 1.1 (note that these are supposed to be
settable from Preferences in WB 1.2).
<raising voice> Yo, Aegis. Is there a bit to twiddle to increase the pitch
on the area fill patterns, such that they are more filled (more
lines/inch)? I didn't see anything about this in the manual; is there a
page you can point to (typedef page *finger)?