Diga
Gano,
First, congratulations for getting the Amiga!
With Diga! you can open the buffer with a "left Amiga O" and close it
with a "left Amiga N". You can also SIZE the buffer (important!), view the
buffer, clear the buffer and set a "loop mode". There are keyboard commands for
these things, and they are also available under the "CAPTURE" menu.
To save the buffer, look under the "PROJECT" menu, then "SAVE" and then
"BUFFER". The keyboard command for this is "ALT S".
To use Diga! and an editor at the same time, you use the multitasking
capablility of the Amiga. First, "Click" on NotePad to get it running. Next
click on the gadget in the upper right hand corner to get you back to the
WorkBench. Now click on Diga!'s Icon. Now both programs are running at the same
time. Normally, the gadgets in the upper right corner of the window are for
switching between programs, but you can't "get back" to Diga! using them. So,
when you want to switch back to Diga!, you must use the Left Amiga M (left
Amiga N takes you out of Diga!). Try it a few times and it will make sense.
When you compose a message, save it to disk. Compu$erve has two
"editors". One of them allows UPLOADING of messages. This is the one to use.
Just upload the message using Diga!'s "TRANSFER/SEND FILE". All of this can be
done while "on-line", or off-line without exiting either program.
If you want to do any of this from the CLI, you must use RUN with the
first program. For example "RUN Notepad", then you can start Diga!.
You might want to get a copy of TxEd. It also works with Diga! and is
smaller than Notepad.
Lloyd Dull