DP II print
On the DPaintII main screen, in the project menu (and I'm speaking from
memory, not having used the program for quite a while), there are two
options that affect your printouts. One is SET PAGE SIZE; the other, PRINT
PICTURE. For the most accurate printing, first use SET PAGE SIZE, and at
the top of the requester, where it says "Type in size", make the width 840
and the height 720 (assuming 120 dpi width and 72 dpi height for the
printer). Note that these measurements are integral multiples of the dpi
in each case. Be sure to press return after each number you type in, else
it will be ignored. Then, in the PRINT PICTURE requester, use 100% for
both % high and %wide.
This is a very condensed version of Dick's advice for good print. I
haven't tried it in quite a while, but recall that it did make a
remarkable improvement. He also tells how to double the size, etc. – but
the article was about 10 pages long…..