CompuServe Messages

[ continuation ] MemPri also says I have 1 Meg for Chip ram and even reveals the start and end address. Their difference is the same value both programs say I have for chip ram. To me, this says Agnus and the installation is OK. The only sin I can think of that I may have done is that I don't think I had to remove the 2090A to replace Agnus. The MW and the GVP allowed me enough room. I, therefore, drilled the hole in the back of the case with the 2090A in the vicinity which would cause it to assume some vibration. I didn't knock the h… out of it, and drilled with a 3/32, 5/32 and then the 1/4. If I autoboot off the ICD / Syquest, I still get errors on the Rodime partitions when accessing them. No errors ever appear on the Syquest. The kicker: I just did a cold reboot with that switch thrown. I now have only a 1 Meg, chip computer. I have no cartridge in the Syquest. The Rodime is showing NO errors. It is perfect. This should finger the now dead GVP board, only it worked fine until Agnus came along. What do I do next? I smell buss contention, but fail to see how this would manifest itself in read/write "errors". Regards Tom