CompuServe Messages

Don: Metal chips? Metal chips? 😎 Hey, I literally stuck the tip of a large Electrolux Tank vacuum to that pad when I was done. That sucker could have been used to remove the Agnus chip. 😎 What I found is that my SetCpu program is at "fault". If I downgrade it to DATA NOCACHE, my computer is fine. Only the Ronin test program says I am down to 7.83 * A1000 whereas otherwise, it was at 10.96 * it. The MaxTransfer didn't help. I had pulled one partition down to 512! and still got the read/write errors. My other controller in the computer is an ICD Advantage 2000. It drives an external Syquest. I can autoboot off the Syquest with no sweat. It is fine. But all I need to do to get "errors" is to read from the Rodime. I will call GVP, now that you mention it. They are only a few miles from where I live. (See…you should have stayed in Haverford. <grin> ) I'll ask you what I just asked ICD-Craig: Are you aware of any software that will do a full performance check on the Fat Agnus? There is still a chance it is doing me in. Like someone else who exchanged his, I tried GoPal on it and got a munged screen. I didn't try it, though, with the A3001 switched out. (The 3001 doesn't have autoboot EPROMS either), Regards Tom