CompuServe Messages

Used the autoexec.bat and config.sys as you'd editted them, and the computer hung as I indicate below in my message to Stac. Let me know if you don't think it's their question. Thanks again for the help! <<<<<<<<<Help!!! I'm trying to get a clean boot of my system to see if either Netroom or Stacker are causing a "Divide by zero" error when I try to launch Digital Processing System's Personal Animation System software. Interestingly, I am able to launch the software from Windows and bring up the interface, but the software will not work entirely correctly in Windows. I started by asking Helix software (makers of the memory manager that I use – Netroom 3.02) to help me manually strip out their memory manager. This was necessary because when I tried to use Netroom's Customize facility to remove Netroom, but my computer hung right after Stacker.com loaded (right after the Registered to information appears). Unfortunately, after using the revised Autoexec. and config. files shown below (based on my current settings), the computer STILL hangs after Stacker loads. I cannot get Netroom out of the loop, and I'm not sure what to do next to have the simplest startup files, while still allowing Stacker to load. >>>>>>