Help with Video (part 2)
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
Doug, the video line must be terminated with 75 ohms. Most monitors are
terminated internally, but check the back of yours for a switch. If the
video input is "looped-thru" (i.e. two inputs tied together) then you may
have to supply the 75 ohms with a terminating plug from an electronics
store (but this isn't likely unless you have a professional montior). By
all means try it on another monitor. The video off the DIN plug is
separate from the composite output, but uses the same circuit design. If
you suspect the composite driver circuit you can try the DIN plug, but it
isn't likely to be the problem. Good luck! —Mike