#TARGA Help!
I just bought a TARGA+ and I can't seem do get 3DStudio to output to it
correctly. I am using the driver that came with 3DStudio and am sure I have
it setup correctly in my AUTOEXEC.BAT: –
SET RDPADI=c:\3ds\drivers\rdptarga.exp
I think my problem is I don't know what to set the I\O switches on the
TARGA board to. I tried the default settings but when I try to render to
the RDPADI device in 3DStudio, my VGA monitor becomes a mess with strange
artifacts (The TARGA board is connected another RGB Analog monitor). Why
would this effect my VGA monitor?
And yes, I am using the SET TARGASET=T32 setting in my AUTOEXEC.BAT file to
simulate an older TARGA 32 board.
Does anyone have any suggestions?
Thanks loads
Scott Bowman