memory
PMFJI, but I think I may be able to help.
Your Workbench: partition on your HD is definately full. See what is out there
that you don't need and either delete it or move it to your Work: partition.
Ram: disk is allways goig to report that it is 100% full. That is because it
only uses enough memory to hold it's contents. You can add things to the Ram:
disk even though it says 100% full.
If you have a 4MB SIMM in your MBX 1200z and the Workbench titlebar is saying
1,390,696 graphics mem, 0 other memory, then your MBX is not working right.
The graphics mem is your Chip memory, the other memory should be your 4MB SIMM,
which is saying 0. Check your MBX or the SIMM; make sure they are both seated
ok.
You should be able to load AutoPilot on you Work: partition with no problems,
but you will need to clean up your Workbench: partition first (AutoPilot does
put some things in your Workbench: partition, such as ApAssist, and you do not
have enough free space to put anything there).
Hope this helps.
— Dogs crawl under Gates, Software crawls under Windoze —
Rick Green via AutoPilot 1.74